I am setting up an ethernet bridge with one wireless interface and have a problem getting it to work. I know the wireless and ethernet cards both can connect to the network without the bridge setup, so I know both interfaces are working on their own. But after creating br0, adding both interfaces to br0, bringing both interfaces up with 0.0.0.0 as IPs and then bringing br0 up, the bridge still does not work. I even setup a bridge with just two wired ethernet cards and that did work for me, so I know that I am doing the right steps and my kernel works with bridging.
Do I need to do something special with my wireless card in order to get it to work in a bridge? I have seen some info about needing a wireless card that can do master (AP) mode. Is this required for bridging? I only want the wireless card to connect up to an access point, I do not want it to act as an access point itself. any help would be great. Thanks bjz _______________________________________________ Bridge mailing list [EMAIL PROTECTED] http://www.math.leidenuniv.nl/mailman/listinfo/bridge
