21.12.2020 9:56, Frans-WIllem Post пишет:
Hello all,
Would someone be able to help me with getting BrlTTY running on Fedora
33, see below? My braille display says "Not in text mode" while in
GUI. On the TTY-consoles, however, it works perfectly.
Thank you very much.
Frans-Willem Post
On 15-12-2020 21:41, Frans-WIllem Post wrote:
Hello,
Can someone point me to the steps to get BrlTTY running in GUI mode
with Orca? I'm using Fedora 33 and an X.org server instead of Wayland.
On the system's TTY-consoles, BrlTTY works perfectly. I only had to
enable and start the service like this:
sudo systemctl enable brltty;
sudo systemctl start brltty;
It even uses my personal Braille table, as set in /etc/brltty.conf.
- In Orca (master), I have Braille support enabled.
- BrlTTY is in version "6.1 rev unknown".
- I'm using a Freedom Scientific Focus 40 Blue via USB, but it is
detected as a "Freedom Scientific Focus 3" by lsusb.
Thanks for your help!
Kind regards,
Frans-Willem Post
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.app/mailman/listinfo/brltty
does your user in brlapi group?
--
Sincerely, Alexander.
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.app/mailman/listinfo/brltty
