Dear BRLTTY community,
I recently switched to using a Unified Kernel Image to boot my laptop.
I'm using Dracut to generate the image, following guidance on the Arch
Linux wiki. During image generation, errors are reported regarding
BRLTTY-related devices not being found.
I can capture the error messages if this is not a known issue.
After the system boots to a graphical login manager, BRLTTY is running
but it reports "no key bindings" on the display. The work-around is to
restart BRLTTY by shutting down the braille display and then re-enablig it.
Has anyone been here before, and is there a known solution?
The unified kenrel image is executed directly by the UEFI firmware, so
there is no boot loader anymore.
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.app/mailman/listinfo/brltty
