Hello,
I forgot the most important thing:
Instructions for brltty are in ./doc/en/README.brltty in the source
archive.
I attach the version of README.brltty found in mlterm-3.8.4
Greetings,
Didier
comment -*- mode: text; tab-width:2; indent-tabs-mode:nil -*-
Support brltty with the use of brlapi
* Tested environment
Fedora 25
* Build
$ ./configure --enable-brlapi
$ make
$ sudo make install
$ mlterm -v
mlterm version x.x.x
Features: ... brlapi
* Start
<brltty with xw driver>
$ export BRLAPI_HOST=127.0.0.1:1
$ brltty -b xw -A auth=none,host=127.0.0.1:1
$ mlterm
<brltty with xw and espeak driver>
$ export BRLTTY_SPEECH_INPUT=/foo/bar/fifo
$ export BRLAPI_HOST=127.0.0.1:1
$ sudo mkdir /var/run/brltty
$ brltty -b xw -s es -A auth=none,host=127.0.0.1:1 -i /foo/bar/fifo
$ mlterm
<brltty with tty>
$ sudo brltty -b tt -d `tty`
$ mlterm
* Note
o If BRLTTY_SPEECH_INPUT environmental variable is not set, mlterm doesn't
output anything to speech synthesizer.
o mlterm-fb, mlterm-con or mlterm-wl works with brltty as with mlterm.
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.com/mailman/listinfo/brltty
