Hi, Mario! You wrote:
> Mario Lang <[email protected]> writes: > >> [email protected] (Lars Bjørndal) writes: >> >>> With recent svn versions of BRLTTY, there is something horrible wrong >>> with the USB support on Handy Tech Active Braille. The braille display >>> isn't updated unless you press a key on the display itself. So if brltty >>> is started and you type something at the command line prompt, the typed >>> text isn't on the display untill you press a key on the display. >>> >>> I have firmware version 2.1, which is an unofficial version. >> >> I can now confirm your problem description on a device with Firmware >> 2.5. > > And here is the real fix, relative to subversion HEAD (r6834). Today, I upgraded Active Braille to 2.7 and BRLTTY to rev 6925M. (I had a source rpm, and used that one for now.) I have two problems when running Active Braille on USB: 1. If Active Braille shows the startup message when starting BRLTTY, I get a message about "Saving configuration!". I can cancel that message by pressing esc, and activate PC-mode to operate normally with BRLTTY. However, this seems to be a bug. 2. When exiting BRLTTY, I cannot turn off the Active braille. I do need to reset it by holding the on/off button for a while. Thanks and regards, Lars _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
