[email protected] (Lars Bjørndal) writes: > Today, I upgraded Active Braille to 2.7 and BRLTTY to rev 6925M. (I had > a source rpm, and used that one for now.) I have two problems when > running Active Braille on USB: > > 1. If Active Braille shows the startup message when starting BRLTTY, I > get a message about "Saving configuration!". I can cancel that message > by pressing esc, and activate PC-mode to operate normally with BRLTTY. > However, this seems to be a bug.
I still see this occasionally, but the good new is: > 2. When exiting BRLTTY, I cannot turn off the Active braille. I do need to > reset it by holding the on/off button for a while. That this bug has just been fixed since revision 8157. Took us more then thausand commits to (accidentally) find this. :-) -- CYa, ⡍⠁⠗⠊⠕ | Debian Developer <URL:http://debian.org/> .''`. | Get my public key via finger mlang/[email protected] : :' : | 1024D/7FC1A0854909BCCDBE6C102DDFFC022A6B113E44 `. `' `- <URL:http://delysid.org/> <URL:http://www.staff.tugraz.at/mlang/> _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
