I am trying to get PPPD working on an ARM based processor (actually a Marvell PXA310 XScale). I am running BusyBox v1.01 and Linux Kernel v 2.6.21
have compiled kernel with the following flags set: CONFIG_PPP=y CONFIG_PPP_MULTILINK=y CONFIG_PPP_FILTER=y CONFIG_PPP_ASYNC=y CONFIG_PPP_SYNC_TTY=y CONFIG_PPP_DEFLAGE=y CONFIG_PPP_BSDCOMP=y CONFIG_PPP_MPPE=y CONFIG_PPPOE=y CONFIG_SLIP=y And indeed as the kernel loads I see the following: PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered PPP MPPE Compression moduel registered NET: Registered protocol family 24 SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256) I have downloaded the PPP Daemon (pppd) v 2.4.4 source code from the samba website: ftp://ftp.samba.org/pub/ppp/ ppp package cross compiles fine and is added into to the filesystem image as it is compiled. When I run "pppd", the console terminal will hang outputting nothing. I expect to see something similar to this however: ~�}#�!}!}!} }4}"}&} } } } }%}&�.�O}'}"}(}"F�~ which would be authentication/handshaking attempts with a modem. If I tell pppd to use Serial Port 2 "ttyS1" or any other serial port than the currently connected consonole's port, the daemon immediatly unloads. Anyone have experience/insight into what could be going wrong?
_______________________________________________ busybox mailing list [email protected] http://lists.busybox.net/mailman/listinfo/busybox
