Ralph, I agree. I was trying to keep my answer short and in doing so I left
out a lot. I just wanted to point out that his radio is most likely
grounded through the house wiring and then to a ground rod close to the
house entry point. As to whether another ground would give better
reception, well, I'm not even going there.


73 -- Roy Storey W5TKZ



On Tue, Jul 15, 2014 at 3:47 PM, ralphcheek via BVARC <[email protected]>
wrote:

> Roy,
> That round pin on the plug is an AC (&DC) ground but not much of a radio
> frequency (RF) ground.
> I use a flat copper brade that is 1 inch wide out to three 10' long copper
> ground rods in a triangle formation seperated by 18 inches for a minimum RF
> ground.
> Hole you find this helpful.
> 73,
> Ralph, KL7AX
>
> Sent from my Verizon Wireless 4G LTE smartphone
>
>
>
> -------- Original message --------
> From: Roy Storey via BVARC <[email protected]>
> Date: 07/15/2014 3:28 PM (GMT-06:00)
> To: Gayle Dotts <[email protected]>,BRAZOS VALLEY AMATEUR RADIO CLUB <
> [email protected]>
> Subject: Re: [BVARC] Grounded radio in shack
>
>
> You may think your radio is not grounded, but if it has a polarized with a
> ground pin (the round one) on the power plug and if the house wiring is up
> to code, I think you are grounded.
>
>
> 73 -- Roy Storey W5TKZ
>
>
>
> On Tue, Jul 15, 2014 at 12:04 PM, Gayle Dotts via BVARC <[email protected]>
> wrote:
>
>> My radio is currently not grounded.  Beyond the obvious power surge
>> possibility that exists, is there an increase in reception to be obtained
>> available due to radio grounding?
>>
>> _______________________________________________
>> BVARC mailing list
>> [email protected]
>> http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
>>
>>
>
> _______________________________________________
> BVARC mailing list
> [email protected]
> http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
>
>
_______________________________________________
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org

Reply via email to