bob:
on rig interface setting select Icom. thenselect a com port not in
use. I choose 5 or 8. Set the baud rate as per you Radio specs. mine works
at 38.4. parity select none. Data bits 8. Stop bit 2. Connection power RTS.
polling 2 sec.
If this does not work then go to the following link http://www.n3fjp.com
is were I got my information.
Gerald Muller K9GEM
[email protected]
In a message dated 8/7/2015 5:54:26 P.M. Central Daylight Time,
[email protected] writes:
Anybody have an N3FJP config file for an Icom radio? It appears to not
be model specific, but I have a 718.
Thanks,
Bob
Sent from my iPad
_______________________________________________
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
_______________________________________________
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
