I hate to jump in but will anyway. I was having trouble decoding and found the the K3 had switched to USB. also I now have added a MicroHAM Interface III and my audio levels were not set. Robie suggested that I set USB to LSB and play with the Audio levels. By the time I got it working , the contest was over. I wrote everything down so I won't have that problem again and will start the set up the day or so before the contest. Lessons learned. From a rookie. Gerald Muller K9GEM gmuller...@aol.com In a message dated 2/12/2018 11:17:11 AM Central Standard Time, bvarc@bvarc.org writes: Suddenly, the signal levels on the MMTTY scope seem to be very low. In addition, only the loudest signals are decodable. Nothing in my configuration has changed (that I know of) except that I did an upgrade to the microHAM micro KEYER II firmware. (I am not saying that is the cause, but the only thing that I know of that has changed). I have been using FT8 a lot these days, but I don't see how that can make a difference.
Rig: K3/P3 Interface: micro KEYER II v6.12 with Device Router v8.8.4. I have checked all cables and setting that I know of to set. Audio levels are mostly set to max and yet the cross hair display on MMTTY shows low levels. In addition, the audio seems distorted on receive (at least the image is distorted). On transmit, all levels are normal and the image is clean. Any ideas?? Allen R. Brier N5XZ 1515 Windloch Lane Richmond, Texas 77406-2553 (281) 342-1882 (Home) (713) 705-4801 (Cell) _______________________________________________ BVARC mailing list BVARC@bvarc.org http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Message delivered to gmuller...@aol.com
_______________________________________________ BVARC mailing list BVARC@bvarc.org http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Message delivered to arch...@mail-archive.com
