Blue loctite.
________________________________
From: BVARC <[email protected]> on behalf of Larry Brand via BVARC
<[email protected]>
Sent: Wednesday, June 1, 2022 12:29 AM
To: BRAZOS VALLEY AMATEUR RADIO CLUB <[email protected]>
Cc: Larry Brand <[email protected]>
Subject: Re: [BVARC] Fixing a stripped aluminum screw hole
Could try pipe thread tape . Or this paint on fingers might be like a
glue . Larry Brand kb5pnu .
On Tue, May 31, 2022 at 11:29 PM Mark Brantana via BVARC
<[email protected]<mailto:[email protected]>> wrote:
Here's a question everyone is likely to encounter at some time, and I am hoping
someone has an answer. There are tiny screws holding the back of my macbook
air. The pentalobe size is 1.2, and the screw shaft size appears to be around
0.75 mm. The screw appears to be stainless steel, and the case appears to be
aluminum. The screw appears to be fine, but the hole is stripped. Does anyone
have a solution for properly and permanently fixing the hole?
Mark
N5PRD
________________________________________________
Brazos Valley Amateur Radio Club
BVARC mailing list
[email protected]<mailto:[email protected]>
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Publicly available archives are available here:
https://www.mail-archive.com/[email protected]/
________________________________________________
Brazos Valley Amateur Radio Club
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Publicly available archives are available here:
https://www.mail-archive.com/[email protected]/
