Hi Nate,

I just scored an ICOM 735 from Jeff, a club member, for $350. Please let me
know if you get other offers for equipment!

I have a uSDX+ (white buttons) QRP unit. I have made contact with it on 20
meters and 40 meters. There are lots of variants, all based on the same
design.
See: https://youtu.be/3SF-0ApxCNg

I use a linked end-fed half-wave, screwed to the top of the backyard fence,
for these two radios. I start on one side of the fence and just keep going.
There are linked breaks at 20 meters and 40 meters, and the full length is
80 meters.

For 2 meters and 70 cm, I use my TIDRADIO H3 and an external antenna, set
up in the back yard. I have made several different 2m antennas, including
1/4 wave ground plane, 1/2 wave vertical dipole, J Pole,
broomstick/flowerpot, and Yagi. All were huge improvements on the rubber
ducky that came with the HT. I set them up and take them down any time I
use them.

I am happy to share my notes on antennas!

73
Dan KJ5IZK


On Fri, Mar 13, 2026 at 12:14 AM Comcast via BVARC <[email protected]> wrote:

> Good morning all,
>
> Looking for a used HF transceiver or some ideas to get on the air and put
> my general class license to use. At this point, I wouldn’t count out QRP.
> I’m dying to get a setup and start making contacts. I live in a very
> restrictive POA and will have to run a stealth/ portable setup.
>
> Any advice, help or know where to go for some used gear please email me.
> All the best.
> -KO4YFB
>
>
>
> ________________________________________________
> Brazos Valley Amateur Radio Club
>
> BVARC mailing list
> [email protected]
> http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
> Publicly available archives are available here:
> https://www.mail-archive.com/[email protected]/
>
________________________________________________
Brazos Valley Amateur Radio Club

BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Publicly available archives are available here: 
https://www.mail-archive.com/[email protected]/ 

Reply via email to