On Jul 20, 2012, at 5:06 PM, Colin Reveley wrote: > Is it possible to inflate just part of a surface? I doubt it.
Inflate, I don't think so; smooth -- definitely. You can use paint to select nodes, then constrain the smoothing that way. I don't have caret handy, but look at the options under Surface: Geometry. > > I am experiencing my usual agony in smoothing the medial wall of my surfaces. > as you can see, the medial wall region is very complicated and hard to make > into a smooth sheet, with big convexities, big concavities, and loads of > smaller ones. > > Actually I can't even make a crossover free sphere from this one. > > yes, I can change my segmentation by hand. but at the risk of losing > accuracy. altering the segmentation is normally what I do. aside from being a > bit dodgy, it's also very laborious. > > another way is to smooth it piecemeal, but this example is probably too far > gone for that. > > can't I just suck those nodes out of there?! > > best, > > Colin > <capture.jpg>_______________________________________________ > caret-users mailing list > caret-users@brainvis.wustl.edu > http://brainvis.wustl.edu/mailman/listinfo/caret-users _______________________________________________ caret-users mailing list caret-users@brainvis.wustl.edu http://brainvis.wustl.edu/mailman/listinfo/caret-users
