I'm going to remove the reconfigurable blocks from the FFT blocks today. Glenn
On Tue, Aug 19, 2008 at 9:40 AM, Jason Manley <[email protected]> wrote: > Hey Andrew > > Terry, Mark and I were actually chatting about this yesterday. > > I think this might be due to the use of the reconfigurable blocks (like > "delay"), which lets you select different blocks (between delay_slr and > delay_bram, for example). The problem seems to be when the mask changes by > selecting a different block and the scripts try to set non-existent > variables; the masks only change after the block has been replaced. > > We really don't need these reconfigurable blocks, and they cause too much > trouble, so I think it might be best to stop using them in the scripts and > explicitly insert the required non-reconfigurable underlying blocks with the > reuse block statement. > > Jason > > > > On 19 Aug 2008, at 05:46, Andrew Martens wrote: > > Hi all >> >> Terry mentioned this problem a while back and it keeps popping up. Not >> sure if anyone has any ideas. >> >> Basically, while opening a design or simulating, the following error will >> occasionally occur. >> >> Warning: casper_library.mdl, line 18706: Invalid setting in SubSystem >> 'casper_library/Correlator' for parameter 'Name'. >> >> This will be followed by something like; >> >> Warning: Library 'casper_library/Delays/delay' not found. >> >> It seems that there is some sort of parsing error in the .mdl file which >> leads to many of the blocks not being loaded and thus not being available. I >> have tried to find this by hand before but have not had success. Removing >> the Correlator subsection doesn't work either, the error 'shifts' to another >> module. I have created the casper library from scratch, copying the blocks >> in, and leaving the Correlator subsection out and that has worked but has >> not been tested extensively i.e the bug may still be lurking in wait. >> >> Any ideas? >> >> Cheers >> Andrew >> >> >> > >
