Hi Alan,
Does iMPACT just give you the big red "Programming Failed" banner? Are
there any useful status messages in the transcript window?
Thanks,
Henry
Alan Hinton wrote:
Hi all,
I have the Roach board up and running with the "roach_bsp.bin" code,
things appear to be good. Now I want to start loading my own FPGA code
using jtag. I can communicate with the device (using IMPACT) but can't
seem to load my code into the FPGA,. I think it might be due to
selectmap, it also appears that the selectmap config switch was done
away with??
So I tried the help command from the prompt and came up with "roachsmap"
command but not sure of the correct format for the parameter. Does this
change the selectmap configuration? If so, what is the correct format?
Or am I doing something else wrong? All I am doing at this point is
turning on/off leds.
Thanks
Alan
