> Hi Matt, > > Did you manage to fix your problem? This design simulates just fine for me > too under 11.4 and 12.1, but we don't have a 11.5 install. > > What version of gcc are you using? Have you tried contacting xilinx > support?
I was wondering what gcc has to do with the simulation in the first place. But I haven't looked under the hood to see what it's really doing. John > > Mark > > On Wed, Jun 2, 2010 at 3:42 PM, John Ford <[email protected]> wrote: > >> > Hi John, >> > >> > The .mdl file is attached. >> >> Hi Matthew. >> >> This simulated fine for me on my 11.3 system, modulo the warnings about >> being created on a newer version... >> >> Of course, bee_xps complains bitterly about the lack of the MSSGE block >> if >> you try to build it. >> >> John >> >> >> > >> > Matthew >> > >> > >> > >> >>> Hi All, >> >>> >> >>> We're trying to get the version 11 tools running on RHEL5, and we've >> >>> run >> >>> into a problem. When we try to simulate designs involving Xilinx >> >>> blocks >> >>> (without any Casper blocks), we get the following error: >> >>> >> >>> "Program "gcc" returned non-zero status (1). >> >>> >> >>> Error occurred during "Simulation Initialization"." >> >> >> >> Can you send the .mdl file? >> >> >> >> John >> >> >> >> >> >>> >> >>> The design consisted of a System Generator block, and a Xilinx >> sampled >> >>> constant sent through a gateway to a scope. The error occurred for >> the >> >>> sampled constant. >> >>> >> >>> We're running: >> >>> RHEL 5.1.19.6 >> >>> Matlab 2009b >> >>> Xilinx ISE 11.5 >> >>> >> >>> >> >>> Has anybody ran into this issue? Any suggestions? >> >>> >> >>> Thanks, >> >>> Matthew >> >>> __________________________________ >> >>> Matthew Stevenson >> >>> Graduate Student of Astrophysics >> >>> >> >>> Ph: (626) 395-4095 >> >>> Fax: (626) 568-9352 >> >>> E-mail: [email protected] >> >>> >> >>> >> >>> >> >>> >> >>> >> >>> >> >>> >> >> >> >> >> > >> >> >> >> >
