Hi Ryan, Are you able to connect over serial and access uboot? If you can boot into borph, can you see if the roach has and IP and tcpborphserver is running?
Also, you can access the Actel Fusion over the Xport which has information about temperatures and voltages. You can get the python script to run it here: https://casper.berkeley.edu/wiki/Roach_monitor_and_management_subsystem Mark On Wed, Jun 22, 2011 at 4:21 PM, Ryan%20Monroe <[email protected]>wrote: > Hey all, > I was testing the GPIO pins on the roach with a wire connected to the gpio > 3.3V line. The other end of the wire brushed across the board very quickly, > most likely touching (if anything) the IIC bus or one of the two coax > ports. The roach shut down and immediately restarted. > > I now receive the following error upon trying to program my roach: > "KatcpClientError: Client not connected" > > Pinging 192.168.0.2 receives no response. > > > Anyone dealt with something like this before? What would be some good > first steps towards repairing the roach? > > --Ryan Monroe >
