Hi David:
probably not. The input to the planahead only system.ngc and ucf files
only, no need of OPB cores or other pcores. The problem is the filenames
of wrappers generated by 14.3 are not correct, shouldn't have the prefix
"system_".
If you compare the filenames of 14.3 and older versions under
/implementation/, you will find the difference.
cheers
homin
On 01/22/2013 01:11 PM, David MacMahon wrote:
Hi, Homin,
Could this problem possibly be caused by planAhead not finding the necessary
OPB cores?
Dave
On Jan 20, 2013, at 6:01 PM, homin wrote:
Hello:
I am trying to push the fabric clock faster and faster, so that i am trying the
newest version 14.3 and planahead.
I got a problem while using planahead 14.3. If the system.ngc compiled by 14.3
toolflow(matlab 2012a, Xilinx 14.3), planahead can't parse the ngc file. The problem is
the V14.3 put the prefix "system_" in the wrapper files, the old versions
didn't. I have tried the system.ngc files by 11.4, the planahead 14.3 can run it without
problem.
There should be somewhere the prefix "system_" can be removed, but i didn't
have good luck.
Anyone have met this problem ?
regards
homin jiang
-----------------------------------------------------------------
[NgdBuild 604] logical block 'epb_opb_bridge_inst' with type
'system_epb_opb_bridge_inst_wrapper' could not be resolved. A pin name
misspelling can cause this, a missing edif or ngc file, case mismatch between
the block name and the edif or ngc file name, or the misspelling of a type
name. Symbol 'system_epb_opb_bridge_inst_wrapper' is not supported in target
'virtex6'.
--------------------------------------------------------------------
