Hi All, I'm trying to run a simple simulation on an ADC block. I'm just changing the frequency of the input sine wave. Unless I refresh the ADC block (change frequency etc) then the simulation fails to run correctly - no sync pulse generated and the output of the ADC is always zero (a scope on the sine simulator does show the correct wave).
I also get the following warning: Warning: did not properly cleanup after previous model termination 2012 Any ideas much appreciated as it's a real pain at the moment to run anything. Ross -- Ross Williamson Research Scientist - Sub-mm Group California Institute of Technology 626-395-2647 (office) 312-504-3051 (Cell)
