Hi Richard, The yellow block should use the roach 2 gpios in the same way as roach 1, so the reset signal should control pin 0 of the gpio bank (though the choice of banks a and b won't make any difference on roach 2, since there's only one). Cheers, Jack On 11 Mar 2014 21:44, "Richard Black" <[email protected]> wrote:
> Hi all, > > I managed to get the x64 ADC card into the ROACH-2 chassis, but now I have > a minor problem. > > The x64 ADC has a negative logic reset pin; unless it is driven to 1, the > x64 ADC outputs -1 on all channels. On ROACH-1, there was a bank of GPIO > pins that we could configure to drive the reset pin. However, I am > unfamiliar with the ROACH-2 architecture and its GPIO pins. Does anybody > know how to connect the x64 ADC reset pin to the ROACH-2 GPIO pins? > > Thanks, > > Richard Black >
