HI guys, Thanks for your information! These are helpful, but we are still confused of how to make the synchronization work. Our goal is to make the 4 ADCs on two ROACH2 boards synchronized. Could any one offer some guidances? Thanks!
Weiwei On Mon, Apr 7, 2014 at 2:48 PM, Jack Hickish <[email protected]> wrote: > Hi Weiwei, > > Rurik et al. are the pros, but the wiki > (https://casper.berkeley.edu/wiki/ADC1x5000-8) says: > > Sync: LVTTL, 5V tolerant, terminated with 50 ohm load, into SMA socket > > On 7 April 2014 14:36, Weiwei Sun <[email protected]> wrote: > > Hi Rurik, > > > > An synchronization is required for multiple ADCs. We noticed the sync > port > > on the ADC, but we don't know how to use it. For example, from the > EV8AQ160 > > datasheet, it mentioned the signal for sync is LVDS, but the port is SMA > > type. Could you give me some suggestions or comments on how to make it > work? > > We are really appreciated! Thanks! > > > > Weiwei > > > > -- > > Weiwei Sun > > Radar Remote Sensing Lab > > Department of Electrical Engineering > > University of Washington (Seattle) > -- Weiwei Sun Radar Remote Sensing Lab Department of Electrical Engineering University of Washington (Seattle)
