Hello, I finished set up the tool flow, which seems to work properly. I can start the environment by running 'startsg' without any errors. But I had errors when I tried to simulate a SNAP tutorial -- snap_tut_intro.slx. Please see the error message below:
[cid:8bf2c6cd-e2fc-4e27-9389-50c56fdf6239] All the 3 errors are about the data width of the input data. The following shows where the error happens: 1, The gateway_in in the yellow block of input a: [cid:13b312a0-4184-40cd-8af9-792af7a941d0][cid:5fe41d5e-4e6a-4ded-a2ee-67190979d9aa] 2, the s function in the yellow block of input a, the same picture as shown above. 3, the delay block in the sum_a_b output [cid:1e256c9f-0180-459c-802a-bd450659abd8] [cid:3189cf84-9dfd-4a2b-a1a5-a1809dc14594] Except the first one, that I can see the output data from the gain_1 is ufix64_En31, which I am not sure it is 32 bits or 64 bits, the rests are 32 bits. So I am wondering if this mismatched data width from the environment or not? Could it relate to my tool flow setup? Any suggestions that I can try to narrow down this problem will be very helpful. Thanks in advance! Xin -- You received this message because you are subscribed to the Google Groups "casper@lists.berkeley.edu" group. To unsubscribe from this group and stop receiving emails from it, send an email to casper+unsubscr...@lists.berkeley.edu. To view this discussion on the web visit https://groups.google.com/a/lists.berkeley.edu/d/msgid/casper/YQXPR0101MB138485E5451EC4818A24865CCAD59%40YQXPR0101MB1384.CANPRD01.PROD.OUTLOOK.COM.