I am working on Lab 28 and need to setup MPLS with LDP.....I ran the following commands to begin the basic configuration of my MPLS: (only pertinent info displayed)
Ip cef Mpls ip Mpls ldp router-id loopback 0 Mpls label protocol ldp ! Int ser 0/0.25 Mpls ip ! ...................and here is what shows up in the router configuration: ip cef mpls label protocol ldp tag-switching tdp router-id Loopback0 ! interface Serial0/0.25 point-to-point ip address 150.50.25.2 255.255.255.252 tag-switching ip No matter what I do this always shows up.....I erased the startup configuration and it still always shows this when I configure MPLS. Why would "tag-switching tdp router-id Loopback0" show up instead of "mpls ldp router-id loopback0" ? Kind regards. Christopher Fata | 517.819.4713 | CCIE Written, CCNP, MCSE | netech | www.netechcorp.com<http://www.netechcorp.com> CONFIDENTIAL NOTICE: This electronic transmission and any attachments constitute confidential information which is intended only for the named recipient(s) and may be legally privileged. If you have received this communication in error, please contact the sender immediately. Any disclosure, copying, distribution or the taking of any action concerning the contents of this communication by anyone other than the named recipient(s) is strictly prohibited.
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
