Hi matt,
I've tried that as well. I changed on the topology the path used by the
image and the topology loads correctly.
I am able to run Catx, Rx units but when I start BBx unit (LED is
green) and I try to console into it I only receive message
"Connected to Dynamips VM "BB3" (ID 8, type c2600) - Console port" I
cannot see if image loads correctly or not.
When I start new topology with c2610 the image loads correctly and
everything works fine.
As I don't want to create the topology from the scratch It would be
nice to understand where the problem lies.
Thanks,
Regards,
Lukasz
On Thu, 26 May 2011 22:11:08 +1000, Matt Hill wrote:
Change the router in GNS3 for one you have the IOS licence for.
Cheers,
Matt
CCIE #22386
CCSI #31207
On 26 May 2011 20:44, Lukasz Szalacha <[email protected]> wrote:
Hi All,
I've downloaded the topology and configs from ipexpert site so that
I can
use them on GNS3. As I don't have active support with cisco I am not
able to
download the C2600-j1s3-123-17a.bin image. Is there other image for
2600
that I can use that will include required features for CCIE
studying?
Thanks,
Regards,
Lukasz
_______________________________________________
For more information regarding industry leading CCIE Lab training,
please
visit www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
