Hi Guys,
can anyone of you explain to me please why I could not see the both serial
interfaces of R5, even thought I have connected the both interfaces in the
topology diagram ?
However, there are only one serial interface is available to me to see as
follows:
R5(config-if)#do sh ip ei top 100.100.100.0/24
IP-EIGRP (AS 1001): Topology entry for 100.100.100.0/24
State is Passive, Query origin flag is 1, 1 Successor(s), FD is 819200
Routing Descriptor Blocks:
150.100.100.2 (Serial0/0.56), from 150.100.100.2, Send flag is 0x0
Composite metric is (819200/307200), Route is Internal
Vector metric:
Minimum bandwidth is 10000 Kbit
Total delay is 22000 microseconds
Reliability is 255/255
Load is 1/255
Minimum MTU is 1500
Hop count is 2
As a matter of fact all my serial interface are up and running fine.
my configurations are:
router eigrp 1001
variance 2
redistribute connected metric 1 1 1 1 1 route-map eigrp-connected
passive-interface default
no passive-interface FastEthernet0/0
no passive-interface Serial0/0.56 --------- only this interface is
available to see when I typed #sh ip ei top 100.100.100.0/24
no passive-interface FastEthernet0/1
no passive-interface Serial0/2 --------- This interface is not
available to see when I typed #sh ip ei top 100.100.100.0/24 ----- can
anyone explain to me why this interface is no showing?
network 150.100.25.0 0.0.0.255
network 150.100.100.0 0.0.0.255
network 150.100.220.0 0.0.0.255
network 150.100.221.0 0.0.0.255
no auto-summary
thanks,
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
