Are f1/4 & f1/7 up/up? What devices do you have connected to those ports?
Also remember to add [email protected] and/or click reply all in future messges so everyone can follow the thread. Cheers, Donald Robb Productive Networks / Network Consultant ______________________________________________________________ CCIE Written, CCIP, CCSP, CCDP, CCNP, CCNA: Voice, JNCIP, SCP, MCSA 2003, Security+, CCSE.R65, PACE Experts-Exchange: Guru - R&S From: Ιωαννης ----------- [mailto:[email protected]] Sent: January-24-12 6:22 AM To: [email protected]; [email protected] Subject: RE: [OSL | CCIE_RS] dynamics Hi there , sorry i am having a different problem now. have configured two ports on two switches as layer 3 and i am not able to ping each other . Specifically on CAT 1 CAT1(config-if-range)# do show run inte fas1/7 Building configuration... Current configuration : 111 bytes ! interface FastEthernet1/7 no switchport ip address 150.101.12.1 255.255.255.0 duplex full speed 100 end and on CAT2 interface FastEthernet1/4 no switchport ip address 150.101.12.2 255.255.255.0 duplex full speed 100 not able to ping CAT2(config)# do ping 150.101.12.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 150.101.12.1, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) Both show as up, up any ideas? thanks for all your help Yiannis _____ Date: Mon, 23 Jan 2012 18:36:28 -0800 Subject: Re: [OSL | CCIE_RS] dynamics From: [email protected] To: [email protected] CC: [email protected]; [email protected] I made simiilar type topo working without VTP enabled. 2012/1/23 Donald Robb <[email protected]> I played around with it for a bit and found there is no way for this design to work. The switch modules are conflicting with the router and won't even talk to the other switchports on the same router. Neat idea though Cheers, Donald Robb Productive Networks / Network Consultant ______________________________________________________________ CCIE Written, CCIP, CCSP, CCDP, CCNP, CCNA: Voice, JNCIP, SCP, MCSA 2003, Security+, CCSE.R65, PACE Experts-Exchange: Guru - R&S From: Ιωαννης ----------- [mailto:[email protected]] Sent: January-23-12 12:53 PM To: [email protected] Subject: RE: [OSL | CCIE_RS] dynamics Basically everything looks ok and here is the relevant output ... R5 ------------ interface FastEthernet0/0 ip address 150.100.220.5 255.255.255.0 speed 100 full-duplex CAT 1 --------------------- CAT1#show cdp nei Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R1 Fas 1/1 138 R S I 3725 Fas 0/0 CAT2 Fas 2/13 130 R S I 3725 Fas 2/13 R5 Fas 1/5 158 R S I 3725 Fas 0/0 interface FastEthernet1/5 switchport access vlan 567 duplex full speed 100 interface FastEthernet2/13 switchport mode trunk duplex full speed 100 ! CAT1#show vtp sta VTP Version : 2 Configuration Revision : 0 Maximum VLANs supported locally : 36 Number of existing VLANs : 6 VTP Operating Mode : Transparent VTP Domain Name : ipexpert VTP Pruning Mode : Disabled VTP V2 Mode : Disabled VTP Traps Generation : Disabled MD5 digest : 0x68 0xB7 0x3C 0x37 0xB2 0x5F 0x37 0x41 Configuration last modified by 0.0.0.0 at 3-1-02 00:13:05 CAT1#show inter trun Port Mode Encapsulation Status Native vlan Fa2/13 on 802.1q trunking 1 Port Vlans allowed on trunk Fa2/13 1-4094 Port Vlans allowed and active in management domain Fa2/13 1,567 Port Vlans in spanning tree forwarding state and not pruned Fa2/13 1,567 CAT1#show vlan-swi brief VLAN Name Status Ports ---- -------------------------------- --------- ------------------------------- 1 default active Fa1/2, Fa1/3, Fa1/4, Fa1/6 Fa1/7, Fa1/8, Fa1/9, Fa1/10 Fa1/11, Fa1/12, Fa1/13, Fa1/14 Fa1/15, Fa2/0, Fa2/1, Fa2/2 Fa2/3, Fa2/4, Fa2/5, Fa2/6 Fa2/7, Fa2/8, Fa2/9, Fa2/10 Fa2/11, Fa2/12, Fa2/14, Fa2/15 567 VLAN0567 active Fa1/5 1002 fddi-default act/unsup 1003 token-ring-default act/unsup 1004 fddinet-default act/unsup 1005 trnet-default act/unsup CAT 2 ----------------- CAT2#show cdp nei Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R6 Fas 1/6 177 R S I 3725 Fas 0/0 CAT1 Fas 2/13 167 R S I 3725 Fas 2/13 interface FastEthernet1/6 switchport access vlan 567 duplex full speed 100 CAT2#show inter trun Port Mode Encapsulation Status Native vlan Fa2/13 on 802.1q trunking 1 Port Vlans allowed on trunk Fa2/13 1-4094 Port Vlans allowed and active in management domain Fa2/13 1,567 Port Vlans in spanning tree forwarding state and not pruned Fa2/13 1,567 CAT2#show vtp sta VTP Version : 2 Configuration Revision : 0 Maximum VLANs supported locally : 36 Number of existing VLANs : 6 VTP Operating Mode : Transparent VTP Domain Name : ipexpert VTP Pruning Mode : Disabled VTP V2 Mode : Disabled VTP Traps Generation : Disabled MD5 digest : 0x68 0xB7 0x3C 0x37 0xB2 0x5F 0x37 0x41 Configuration last modified by 0.0.0.0 at 3-1-02 00:02:35 CAT2# show vlan-sw brief VLAN Name Status Ports ---- -------------------------------- --------- ------------------------------- 1 default active Fa1/0, Fa1/1, Fa1/2, Fa1/3 Fa1/4, Fa1/5, Fa1/8, Fa1/9 Fa1/10, Fa1/11, Fa1/12, Fa1/13 Fa1/14, Fa1/15, Fa2/0, Fa2/1 Fa2/2, Fa2/3, Fa2/4, Fa2/5 Fa2/6, Fa2/7, Fa2/8, Fa2/9 Fa2/10, Fa2/11, Fa2/12, Fa2/14 Fa2/15 567 VLAN0567 active Fa1/6, Fa1/7 1002 fddi-default act/unsup 1003 token-ring-default act/unsup 1004 fddinet-default act/unsup 1005 trnet-default act/unsup R6 interface FastEthernet0/0 ip address 150.100.220.6 255.255.255.0 speed 100 full-duplex R6#ping 150.100.220.5 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 150.100.220.5, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) > From: [email protected] > To: [email protected]; [email protected]; [email protected] > Subject: RE: [OSL | CCIE_RS] dynamics > Date: Mon, 23 Jan 2012 12:02:54 -0700 > > What happens exactly? Does it take the trunk command on both ports and > doesn't trunk? Or you get a command error? > How is dynamips configured? > > Cheers, > Donald Robb > Productive Networks / Network Consultant > ______________________________________________________________ > CCIE Written, CCIP, CCSP, CCDP, CCNP, CCNA: Voice, JNCIP, SCP, MCSA 2003, > Security+, CCSE.R65, PACE > Experts-Exchange: Guru - R&S > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Di Bias, Steve > Sent: January-23-12 10:17 AM > To: Ιωαννης -----------; [email protected] > Subject: Re: [OSL | CCIE_RS] dynamics > > Can you post your configs? > > Steve Di Bias > CCIE #32840 > > Ιωαννης ----------- <[email protected]> wrote: > > > Hi there, > I am having a problem with dynamics. Specifically I am not able to trunk > between two swithes (3725). Although the link shows as a trunk(dot1q > hardcoded) and I am able to assign ports to the correct VLANS I am not able > to ping from one router to another across the two switches (vlans are going > across according to the output). Any ideas guys? > Thanks very much > Yiannis > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com <http://www.ipexpert.com/> > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com <http://www.platinumplacement.com/> > > http://onlinestudylist.com/mailman/listinfo/ccie_rs > > > UHS Confidentiality Notice: This e-mail message, including any attachments, > is for the sole use of the intended recipient (s) and may contain > confidential and privileged information. Any unauthorized review, use, > disclosure or distribution of this information is prohibited. If this was > sent to you in error, please notify the sender by reply e-mail and destroy > all copies of the original message. > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com <http://www.ipexpert.com/> > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com <http://www.platinumplacement.com/> > > http://onlinestudylist.com/mailman/listinfo/ccie_rs > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com <http://www.ipexpert.com/> Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com <http://www.platinumplacement.com/> http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
