Paul,
It all depends on your definition of highest J I believe the bullet point is leading you to do preemption. So highest could probably be better phrased as lowest J. We will get that updated as well. Regards, Tyson Scott - CCIE #13513 R&S and Security Technical Instructor - IPexpert, Inc. Telephone: +1.810.326.1444 Cell: +1.248.504.7309 Fax: +1.810.454.0130 Mailto: <mailto:[email protected]> [email protected] Join our free online support and peer group communities: <http://www.IPexpert.com/communities> http://www.IPexpert.com/communities IPexpert - The Global Leader in Self-Study, Classroom-Based, Video On Demand and Audio Certification Training Tools for the Cisco CCIE R&S Lab, CCIE Security Lab, CCIE Service Provider Lab , CCIE Voice Lab and CCIE Storage Lab Certifications. From: [email protected] [mailto:[email protected]] On Behalf Of Paul Stewart Sent: Friday, May 01, 2009 1:52 PM To: [email protected] Subject: [OSL | CCIE_Security] Lab 7A HSRP I am a little confused on this one, but I'm pretty sure I understand HSRP. The task is to assign a sub interface to R5, R6 and R7 with the network of 7.65.0.x. The interface address would have the fourth octet as the router number (I.E. 5, 6, 7). According to 7.3, the R5 should have a priority of 110 AND should be the active HSRP speaker. The next bullet point says that in the event of a failure and recovery the router with the highest IP address will always become the speaker. Since the task is to set the standby group up on R5 and R6, the latter would have the higher IP address. So it seems to me that the second and third bullet in 7.3 contradict one another.
