Dave, Would saving the config have helped here? The initial config loaded by the IPexpert scripts have also disappeared.
Johan -----Original Message----- From: Dave Craddock [mailto:[email protected]] Sent: 27 June 2009 08:32 To: Johan Bornman; [email protected] Subject: RE: [OSL | CCIE_Security] Router crashed Hi john To me that sounds like one of two things? Either the config register is set to no load the startup or you havn't been saving at regular intervals. I always do a copy run flash as well as a copy run start so if the router crashes you can do a copy flash start/run and get back to where you were quickly. As for the proctor he would have to reload and then mabye you would get some extra time but not a lot and if this happens as say 7 hours in you are up the creak without a paddle as they saw as there would be little chance of you getting the full config back on if you havn't saved it to the flash that is dave -----Original Message----- From: Johan Bornman <[email protected]> Sent: 27 June 2009 06:39 To: [email protected] <[email protected]> Subject: [OSL | CCIE_Security] Router crashed Hi, Was doing Lab2A task 2.16. The router and I must have been in the same state of mind with this task. The router crashed. Just wanted to make you (IPExpert) aware. The router then rebooted and started with: Would you like to enter the initial configuration dialog? [yes/no]: % Please answer 'yes' or 'no'. What will happen if this happens in the exam? Will I get time credit and the procotor has to repair (Load initial config, etc) See crash info below. Rgds Johan Crash info: %ALIGN-1-FATAL: Illegal access to a low address 06:44:48 UTC Sat Jun 27 2009 addr=0x1, pc=0x642246F0 , ra=0x63C53F7C , sp=0x68E92AE8 %ALIGN-1-FATAL: Illegal access to a low address 06:44:48 UTC Sat Jun 27 2009 addr=0x1, pc=0x642246F0 , ra=0x63C53F7C , sp=0x68E92AE8 06:44:48 UTC Sat Jun 27 2009: TLB (store) exception, CPU signal 10, PC = 0x642246F0 -------------------------------------------------------------------- Possible software fault. Upon reccurence, please collect crashinfo, "show tech" and contact Cisco Technical Support. -------------------------------------------------------------------- -Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0 0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744 0x62014FE0 0x620154A8 $0 : 00000000, AT : 67210000, v0 : 00000001, v1 : 00000001 a0 : 00000001, a1 : 00000000, a2 : 000000B0, a3 : 00000000 t0 : 0000002C, t1 : 00000000, t2 : 00000001, t3 : 676D0000 t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000002 s0 : 00000001, s1 : 7112CC24, s2 : 00000006, s3 : 68E92B48 s4 : 00000000, s5 : 00000001, s6 : 66E10000, s7 : 660A0000 t8 : 675C7CF0, t9 : 67180000, k0 : 6934AD9C, k1 : 633D8AE0 gp : 6721E3E0, sp : 68E92AE8, s8 : 00000002, ra : 63C53F7C EPC : 642246F0, ErrorEPC : BFC05CFC, SREG : 3400FF03 MDLO : 0012BBE0, MDHI : 00000000, BadVaddr : 00000001 DATA_START : 0x64265E80 Cause 0000000C (Code 0x3): TLB (store) exception Writing crashinfo to flash:crashinfo_20090627-064448 06:44:48 UTC Sat Jun 27 2009: TLB (store) exception, CPU signal 10, PC = 0x642246F0 -------------------------------------------------------------------- Possible software fault. Upon reccurence, please collect crashinfo, "show tech" and contact Cisco Technical Support. -------------------------------------------------------------------- -Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0 0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744 0x62014FE0 0x620154A8 $0 : 00000000, AT : 67210000, v0 : 00000001, v1 : 00000001 a0 : 00000001, a1 : 00000000, a2 : 000000B0, a3 : 00000000 t0 : 0000002C, t1 : 00000000, t2 : 00000001, t3 : 676D0000 t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000002 s0 : 00000001, s1 : 7112CC24, s2 : 00000006, s3 : 68E92B48 s4 : 00000000, s5 : 00000001, s6 : 66E10000, s7 : 660A0000 t8 : 675C7CF0, t9 : 67180000, k0 : 6934AD9C, k1 : 633D8AE0 gp : 6721E3E0, sp : 68E92AE8, s8 : 00000002, ra : 63C53F7C EPC : 642246F0, ErrorEPC : BFC05CFC, SREG : 3400FF03 MDLO : 0012BBE0, MDHI : 00000000, BadVaddr : 00000001 DATA_START : 0x64265E80 Cause 0000000C (Code 0x3): TLB (store) exception -Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0 0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744 0x62014FE0 0x620154A8 === Flushing messages (06:44:49 UTC Sat Jun 27 2009) === Queued messages: L2 ECC Counter = 0000000000000000 Memory and IO Err Counter = 0000000000000000 Bus Watcher Counters cor_l2cache_data_ecc_count = 0 bad_l2cache_data_ecc_count = 0 cor_l2cache_tag_ecc_count = 0 bad_l2cache_tag_ecc_count = 0 cor_memory_data_ecc_count = 0 bad_memory_data_ecc_count = 0 bus_errors = 0 CPU temp is 48 Temp1 temp is 24 Temp2 temp is 22 Internal voltage is 3316 Remote voltage1 is 5153 Remote voltage2 is 2525 Remote voltage3 is 1203
