Dave,
Would saving the config have helped here? The initial config loaded
by the
IPexpert scripts have also disappeared.
Johan
-----Original Message-----
From: Dave Craddock [mailto:[email protected]]
Sent: 27 June 2009 08:32
To: Johan Bornman; [email protected]
Subject: RE: [OSL | CCIE_Security] Router crashed
Hi john
To me that sounds like one of two things?
Either the config register is set to no load the startup or you
havn't been
saving at regular intervals. I always do a copy run flash as well as
a copy
run start so if the router crashes you can do a copy flash start/run
and get
back to where you were quickly.
As for the proctor he would have to reload and then mabye you would
get some
extra time but not a lot and if this happens as say 7 hours in you
are up
the creak without a paddle as they saw as there would be little
chance of
you getting the full config back on if you havn't saved it to the
flash that
is
dave
-----Original Message-----
From: Johan Bornman <[email protected]>
Sent: 27 June 2009 06:39
To: [email protected] <[email protected]
>
Subject: [OSL | CCIE_Security] Router crashed
Hi,
Was doing Lab2A task 2.16. The router and I must have been in the
same state
of mind with this task. The router crashed. Just wanted to make you
(IPExpert) aware.
The router then rebooted and started with:
Would you like to enter the initial configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
What will happen if this happens in the exam? Will I get time credit
and the
procotor has to repair (Load initial config, etc)
See crash info below.
Rgds
Johan
Crash info:
%ALIGN-1-FATAL: Illegal access to a low address 06:44:48 UTC Sat Jun
27 2009
addr=0x1, pc=0x642246F0 , ra=0x63C53F7C , sp=0x68E92AE8
%ALIGN-1-FATAL: Illegal access to a low address 06:44:48 UTC Sat Jun
27 2009
addr=0x1, pc=0x642246F0 , ra=0x63C53F7C , sp=0x68E92AE8
06:44:48 UTC Sat Jun 27 2009: TLB (store) exception, CPU signal 10,
PC =
0x642246F0
--------------------------------------------------------------------
Possible software fault. Upon reccurence, please collect
crashinfo, "show tech" and contact Cisco Technical Support.
--------------------------------------------------------------------
-Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0
0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744
0x62014FE0
0x620154A8
$0 : 00000000, AT : 67210000, v0 : 00000001, v1 : 00000001
a0 : 00000001, a1 : 00000000, a2 : 000000B0, a3 : 00000000
t0 : 0000002C, t1 : 00000000, t2 : 00000001, t3 : 676D0000
t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000002
s0 : 00000001, s1 : 7112CC24, s2 : 00000006, s3 : 68E92B48
s4 : 00000000, s5 : 00000001, s6 : 66E10000, s7 : 660A0000
t8 : 675C7CF0, t9 : 67180000, k0 : 6934AD9C, k1 : 633D8AE0
gp : 6721E3E0, sp : 68E92AE8, s8 : 00000002, ra : 63C53F7C
EPC : 642246F0, ErrorEPC : BFC05CFC, SREG : 3400FF03
MDLO : 0012BBE0, MDHI : 00000000, BadVaddr : 00000001
DATA_START : 0x64265E80
Cause 0000000C (Code 0x3): TLB (store) exception
Writing crashinfo to flash:crashinfo_20090627-064448
06:44:48 UTC Sat Jun 27 2009: TLB (store) exception, CPU signal 10,
PC =
0x642246F0
--------------------------------------------------------------------
Possible software fault. Upon reccurence, please collect
crashinfo, "show tech" and contact Cisco Technical Support.
--------------------------------------------------------------------
-Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0
0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744
0x62014FE0
0x620154A8
$0 : 00000000, AT : 67210000, v0 : 00000001, v1 : 00000001
a0 : 00000001, a1 : 00000000, a2 : 000000B0, a3 : 00000000
t0 : 0000002C, t1 : 00000000, t2 : 00000001, t3 : 676D0000
t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000002
s0 : 00000001, s1 : 7112CC24, s2 : 00000006, s3 : 68E92B48
s4 : 00000000, s5 : 00000001, s6 : 66E10000, s7 : 660A0000
t8 : 675C7CF0, t9 : 67180000, k0 : 6934AD9C, k1 : 633D8AE0
gp : 6721E3E0, sp : 68E92AE8, s8 : 00000002, ra : 63C53F7C
EPC : 642246F0, ErrorEPC : BFC05CFC, SREG : 3400FF03
MDLO : 0012BBE0, MDHI : 00000000, BadVaddr : 00000001
DATA_START : 0x64265E80
Cause 0000000C (Code 0x3): TLB (store) exception
-Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0
0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744
0x62014FE0
0x620154A8
=== Flushing messages (06:44:49 UTC Sat Jun 27 2009) ===
Queued messages:
L2 ECC Counter = 0000000000000000
Memory and IO Err Counter = 0000000000000000
Bus Watcher Counters
cor_l2cache_data_ecc_count = 0
bad_l2cache_data_ecc_count = 0
cor_l2cache_tag_ecc_count = 0
bad_l2cache_tag_ecc_count = 0
cor_memory_data_ecc_count = 0
bad_memory_data_ecc_count = 0
bus_errors = 0
CPU temp is 48
Temp1 temp is 24
Temp2 temp is 22
Internal voltage is 3316
Remote voltage1 is 5153
Remote voltage2 is 2525
Remote voltage3 is 1203
