if you are connected to the FW, say via ssh, do a show fail and see the current state. Disconnect an interface and execute the show failover command again. you will be using the same IP but you should notice now that you are on the either stby or active, depending on what you were on previously.
On Fri, Oct 16, 2009 at 12:03 PM, OSL CCIE Security Lab Exam < [email protected]> wrote: > Hi All, > > > The issue is iam doing active standby.I have got sw1 connected on outside > and sw2 inside.To the switch are connected the routers. > > Iam able to ping the routers ie the traffic is going through the firewall > primary.But iam not able to replicate the failover. > > Suppose if i enable monitor interface on inside and shut down the link on > the sw2 where it is connected to inside interface i cannot see the failover > happening. > when i do show monitor interface everything shows normal.even if i remove > the link.So how should i create the failover scenario. > > I > Regards > Imran > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > -- Chris Schweigert
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
