Is the ping traffic inbound to the interface you've applied input rate-limiting or outbound on the port ?
On Mon, Aug 15, 2011 at 9:08 AM, Umberto Nobile <[email protected]> wrote: > Hi all, **** > > ** ** > > is it possible to using CAR on Catalyst 3560 switch ? I ‘ve tried but it > seems not working.**** > > ** ** > > This is switch config**** > > ** ** > > mls qos**** > > ip routing**** > > ** ** > > Interface FastEthernet0/10**** > > No switchport**** > > Ip address 1.1.1.1 255.255.255.0**** > > rate-limit input access-group 133 8000 1500 2000 conform-action transmit > exceed-action drop**** > > ** ** > > access-list 177 permit icmp any any**** > > ** ** > > when I pinging through f0/10 switch port I don’t match the policy**** > > ** ** > > SW3#sh int f0/10 rate-limit**** > > FastEthernet0/10 ASA - E0/0**** > > Input**** > > matches: access-group 177**** > > params: 8000 bps, 1500 limit, 2000 extended limit**** > > conformed 0 packets, 0 bytes; action: transmit**** > > exceeded 0 packets, 0 bytes; action: drop**** > > last packet: 433627355ms ago, current burst: 0 bytes**** > > last cleared 3d00h ago, conformed 0 bps, exceeded 0 bps**** > > ** ** > > ** ** > > **** > > ** ** > > ** ** > > ** ** > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
