Hi Bruno; I know some guys that work with WSA And I was trying to get the answer from them today but it was bit late...
Im tempted to believe that may be something strictly with the virtual wsa and not with the appliance.. Im sure Sam has the answer, I will try to reach some peers tomorrow and post back Sent from my iPhone On Jun 12, 2013, at 8:59 PM, "Bruno Silva" <[email protected]> wrote: > Mike, so far I have the same issue. Last night I thought of just leaving 1 > interface at all... And it still doesn't work properly... Anttime I set wccp > with transparent proxy the WSA can't get to the destination because of some > routing missbehavior... If you get an answer I would also use it...:P > — > Sent from Mailbox for iPhone > > > On Wed, Jun 12, 2013 at 11:29 PM, Mike Rojas <[email protected]> wrote: > >> Hi, >> >> So I am using a virtual WSA for the WSA book. The main issue that I have is >> that I need to point a route of 192.168.0.0 to the ASA. >> I put the route in place, but all the traffic is still taking the Management >> default gateway to return back to the host that made the request. >> I remember that on the WSA that I used on proctor labs was not having this >> behavior. >> >> Any ideas or suggestions? >> >> Mike. >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
