If you are getting ring through when you place the call, then your GK
config is probably OK. If its ringing that tells me the GK sent the call
to the UCM.
The fact that it goes fast busy when you pick up sounds like a
codec/media problem to me. Check the media resources config and your
regions.
Chris
[email protected] wrote:
I'm working through scenario , trying to get 4 digit dial from BR2 to
HQ working via the HQ GK.
The GK config looks like this.
gatekeeper
zone local UCM ipexpert.com <http://ipexpert.com> 142.1.1.1
zone prefix UCM 1... gw-priority 10 Trunk_2
zone prefix UCM 1... gw-priority 9 Trunk_1
zone prefix UCM 1... gw-priority 0 cmegw
zone prefix UCM 3... gw-priority 10 cmegw
zone prefix UCM 3... gw-priority 0 Trunk_2 Trunk_1
gw-type-prefix 1#* gw ipaddr 142.2.64.12 1720 gw ipaddr 142.2.64.11 1720
no shutdown
I have the UCM registering without a tech-prefix defined and I've
adjusted the "service parameter" to insure the UCM listens on port 1720.
The problem is the call rings through to the HQ DN but comes up fast
busy when I answer the call.
I've attempted to configure the "Trunk" from UCM as both an H.225
Trunk as well as an ICT trunk.
I've unchecked "Wait for far end h.245 terminal capability" as well.
Any help is greatly appreciated.
