Hmm, PSTN to BR1 and IP to IP (inter and intra site) play multicast MoH piano music from route flash just fine, but for some reason when calling from BR1 to the PSTN and pressing HOLD on the BR1 phone it plays beep beep beep.
Usually the issue is PSTN to IP because you need a voice class codec on the SUB/PUB dial peers that support G711, which I have, and PSTN to BR1 piano music streams multicast ok. Not sure what would cause IP to PSTN calls to fail streaming MoH and play beep beep beep. Any ideas? On Oct 7, 2010, at 1:36 PM, ayman labib wrote: > Thanks for the reply. > > As it turns out. Loopback interface is a required step. Now everything is > working. Thanks > > Next challenge is to get Site HQ and SRST to use MoH with CME using the > Gatekeeper. Thanks > > From: ayman labib <ayman_la...@yahoo.com> > To: amr thabt <amrth...@gmail.com> > Cc: ccie_voice@onlinestudylist.com > Sent: Thu, October 7, 2010 3:49:41 PM > Subject: Re: [OSL | CCIE_Voice] MoH to PSTN from SRST site > > Thanks for the reply. > > I do have the max ephone etc.. I removed my config to keep it short. > I tried it with bind command and without. Same Issue. > I don't have Lo0 configured. Everything is configured using the fa0/1 > interface. > > Please have a look at the screen shots of my config. I really appreciate > everyone's help. 2 days and it's driving me crazy. > > call-manager-fallback > secondary-dialtone 9 > max-conferences 8 gain -6 > transfer-system full-consult > ip source-address 192.168.31.10 port 2000 strict-match > max-ephones 10 > max-dn 10 > transfer-pattern .T > voicemail 912123945020 > call-forward pattern .T > call-forward busy 12123945020 > call-forward noan 12123945020 timeout 20 > moh music-on-hold.au > multicast moh 239.1.1.1 port 16384 route 192.168.31.10 > time-zone 8 > ! > > > From: amr thabt <amrth...@gmail.com> > To: ayman labib <ayman_la...@yahoo.com> > Cc: ccie_voice@onlinestudylist.com > Sent: Thu, October 7, 2010 3:07:59 PM > Subject: Re: [OSL | CCIE_Voice] MoH to PSTN from SRST site > > Hi Ayman, > I have three comments that may help > 1 Do you add max-dn and max-ephone under call-manager-fallback > 2-in "ccm-manager music-on-hold bind fa0/1 " remove the bind use only > ccm-manager music-on-hold > 3- in multicast command add both loopback and VLan SVI ip address. > > > HTH > AMR > > > On Thu, Oct 7, 2010 at 9:56 PM, ayman labib <ayman_la...@yahoo.com> wrote: > Just wondering if anyone encountered this problem. > > I still can't get MOH when calling the PSTN phone and the site is not in SRST > mode. According to the sh command below. The call manager has done its job > but the GWY is not responding. Any ideas? MOH local and between HQ works > fine. Just need a sanity check. Thanks for all your help > > SRST-Site#sh ccm-manager music-on-hold > Current active multicast sessions : 1 > Multicast RTP port Packets Call Codec Incoming > Address number in/out id Interface > =================================================================== > 239.1.1.1 16384 0/0 12 g711ulaw > > ccm-manager music-on-hold bind fa0/1 > > call-manager-fallback > ip source-address 192.168.31.10 port 2000 strict-match > moh music-on-hold.au > multicast moh 239.1.1.1 port 16384 route 192.168.31.10 > > > http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00802d1c31.html#wp1046789 > > From: ayman labib <ayman_la...@yahoo.com> > To: ccie_voice@onlinestudylist.com > Cc: ccie_voice@onlinestudylist.com > Sent: Wed, October 6, 2010 9:45:12 AM > Subject: MoH to PSTN from SRST site > > > Hello Experts, > > Follow up to Mark's email about Moh to PSTN. I don't hear the Piano music as > well. Inter-site and Intra-site with HQ works. > > I see the Muticast on the gateway is invoked and on the server, but don't > hear anything. Any idea? Thanks in advance > > admin:show perf query class "Cisco MOH Device" > ==>query class : > > - Perf class (Cisco MOH Device) has instances and values: > MOH_2 -> MOHHighestActiveResources = 1 > MOH_2 -> MOHMulticastResourceActive = 0 > MOH_2 -> MOHMulticastResourceAvailable = 250000 > MOH_2 -> MOHOutOfResources = 0 > MOH_2 -> MOHTotalMulticastResources = 250000 > MOH_2 -> MOHTotalUnicastResources = 250 > MOH_2 -> MOHUnicastResourceActive = 0 > MOH_2 -> MOHUnicastResourceAvailable = 250 > MOH_3 -> MOHHighestActiveResources = 1 > MOH_3 -> MOHMulticastResourceActive = 1 > MOH_3 -> MOHMulticastResourceAvailable = 249999 > MOH_3 -> MOHOutOfResources = 0 > MOH_3 -> MOHTotalMulticastResources = 250000 > MOH_3 -> MOHTotalUnicastResources = 250 > MOH_3 -> MOHUnicastResourceActive = 0 > MOH_3 -> MOHUnicastResourceAvailable = 250 > > > > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
