I had this problem with a recent new install of 8.0.2c (it was pre-installed on
the hard drive on new MCS server) . I couldn't find anything wrong, the
password I reset 20 times, etc.
I upgraded the pub to 8.0.3a and did a subscriber install with software update
on the subscriber and it worked fine.
From: [email protected]
[mailto:[email protected]] On Behalf Of Wael Agina
Sent: Thursday, November 25, 2010 5:29 PM
To: Michael Dietrich
Cc: OSL Group
Subject: Re: [OSL | CCIE_Voice] Adding subscriber problem - need ideas
Dearl Michael
First i have applied license for two nodes and only using one and there is
one available node on the lices [for sub]
Also I set the name with uppercase all lettters and tried on sub both upper
case and lower case but not working.
I did reset security password many times to cisco12345 on pub and used it on
sub but no sccess.
Is there any troubleshooting steps can be done on pub during connectivity test
on sub ?
Regards,
Wael Agina
On Fri, Nov 26, 2010 at 1:23 AM, Michael Dietrich
<[email protected]<mailto:[email protected]>> wrote:
Make sure that you are entering the device name of the PUB correctly (spelling)
during the SUB set up
Make sure the server name for SUB is spelled correctly on the PUB (case
sensitive)...AND..... that you have a second server license installed on the
PUB, to be used by the SUB
On Thu, Nov 25, 2010 at 3:13 PM, Wael Agina
<[email protected]<mailto:[email protected]>> wrote:
Hi Prashant ,
Yes I added it on the publisher on server list and on the CM Group.
But still it fails the connectivity test when installing subscriber software.
Regards,
Wael Agina
On Fri, Nov 26, 2010 at 12:31 AM, Prashant Patel
<[email protected]<mailto:[email protected]>> wrote:
Hi,
Hope you have added the Sub in the list of servers on the Publisher.
HTH
Prashant
On Thu, Nov 25, 2010 at 4:25 PM, Wael Agina
<[email protected]<mailto:[email protected]>> wrote:
Dear All,
I am implemnting new UC project at one customer location.
I installed the first node - publisher - succefully.
Now whenevr i add the 2nd node - subscriber - it tried to test connectivity to
first node but always fails and installion terminated.
There is network connectivity between the two nodes and from publisher i can
ping the new node - subscriber.
Also I reset the security password on the publisher [using Set password user
security on CLI]
Any ideas as the connectivity test always fails ?
--
Thanks and Best Regards,
Wael Agina
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com<http://www.ipexpert.com/>
--
Thanks and Best Regards,
Wael Agina
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com<http://www.ipexpert.com/>
--
Thanks and Best Regards,
Wael Agina
-----------------------------------------
Disclaimer:
This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only. If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful. If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
