Hi Everyone , thanks for clarification !
Regards, Mritunjay 2011/1/18 Roger Källberg <[email protected]> > Then it won't work. > > *Roger Källberg* > CCIE #26199 (Voice) > Consultant > Cygate AB > Eric Perssons väg 21, SE-217 62 MALMÖ > > ------------------------------ > *Från:* Mritunjay Kumar [[email protected]] > *Skickat:* den 18 januari 2011 11:02 > *Till:* Roger Källberg > *Kopia:* Miron Kobelski; [email protected] > *Ämne:* Re: [OSL | CCIE_Voice] Presence btw CUCM and CME > > Hi Roger , > > both cucm and cme phone are sccp phones. > > Regards, > Mritunjay > > 2011/1/18 Roger Källberg <[email protected]> > >> The problem that was stated out in the to the previous tread linked to >> by kobel is for SCCP phones on CME. According to that you will only be able >> to get precense on SIP phones in CME >> >> Snipplet taken from that tread, "I had written notes that Vik said CUCM >> SCCP Phone can't monitor CME phones in 7.0, but SIP should work fine." >> >> What kind of phones do you have on CME, SIP or SCCP? >> >> *Roger Källberg* >> CCIE #26199 (Voice) >> Consultant >> Cygate AB >> Eric Perssons väg 21, SE-217 62 MALMÖ >> ------------------------------ >> *Från:* Mritunjay Kumar [[email protected]] >> *Skickat:* den 18 januari 2011 10:25 >> *Till:* Roger Källberg; Miron Kobelski >> *Kopia:* [email protected] >> *Ämne:* Re: [OSL | CCIE_Voice] Presence btw CUCM and CME >> >> Hi Miron >> >> >> thanks for sharing this. >> >> i can conclude from this link that presence does not for following >> >> phone1-CUCM------SIP -----CME-phone2 >> >> if phone1 is sccp then it cannot see the status of phone2. >> is this correct ? does any doc tell this ? >> >> hi Roger , >> >> I put the RP in partition which is accessible by phone's subscribe CSS but >> did not help :( >> >> Regards, >> Mritunjay >> >> 2011/1/18 Roger Källberg <[email protected]> >> >>> Do you have subscribe CSS assigned to both SIP trunk and phone devices? >>> Also try to add the RP to a partition that is seen in the subscribe CSS, >>> should't make any difference, but I personaly prefer not to use the none PT. >>> Reason is that you have less control of what a specific CSS should be able >>> to "see", but that's just my preference. >>> >>> Sincerely >>> >>> *Roger Källberg* >>> CCIE #26199 (Voice) >>> Consultant >>> Cygate AB >>> Eric Perssons väg 21, SE-217 62 MALMÖ >>> >>> ------------------------------ >>> *Från:* Mritunjay Kumar [[email protected]] >>> *Skickat:* den 18 januari 2011 09:35 >>> *Till:* Roger Källberg >>> *Kopia:* [email protected] >>> *Ämne:* Re: [OSL | CCIE_Voice] Presence btw CUCM and CME >>> >>> Hi All, >>> >>> thank for reply. >>> here is the answer >>> >>> allow watch is configured under ephone-dn >>> set the CUP Publish trunk to respective trunk but did not help. i guess >>> this is only for CUPS >>> >>> subscribe CSS is set to access the phone dn. >>> >>> Regards, >>> Mritunjay >>> >>> 2011/1/18 Roger Källberg <[email protected]> >>> >>>> Hi Mritunjay, >>>> In your config snipplet I don't see any allow watch on your ephone-dn's. >>>> >>>> See this url, >>>> http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_a1ht.html#wp1016553<https://webmail.cygate.se/en/US/docs/voice_ip_comm/cucme/command/reference/,DanaInfo=.awxyCgnyjwImzy+cme_a1ht.html#wp1016553> >>>> >>>> >>>> Sincerely >>>> >>>> *Roger Källberg* >>>> CCIE #26199 (Voice) >>>> Consultant >>>> Cygate AB >>>> Eric Perssons väg 21, SE-217 62 MALMÖ >>>> >>>> ------------------------------ >>>> *Från:* Mritunjay Kumar [[email protected]] >>>> *Skickat:* den 18 januari 2011 06:16 >>>> *Till:* [email protected] >>>> *Ämne:* [OSL | CCIE_Voice] Presence btw CUCM and CME >>>> >>>> Hi All, >>>> >>>> CME phone is able to watch the status of CUCM phone but reverse is not >>>> working. >>>> >>>> config >>>> on CME >>>> >>>> presence >>>> presence call-list >>>> server 14.160.108.20 // .20 is sub >>>> max-subscription 120 >>>> watcher all >>>> allow subscribe >>>> presence enable >>>> >>>> sip-ua >>>> >>>> presence enable >>>> >>>> ephone 2 >>>> device-security-mode none >>>> mac-address 0022.9059.843D >>>> ephone-template 1 >>>> presence call-list >>>> blf-speed-dial 2 2001 label "2001 >>>> >>>> dial-peer voice 321 voip >>>> destination-pattern 2001 >>>> session protocol sipv2 >>>> session target ipv4:14.160.108.20 >>>> incoming called-number . >>>> >>>> >>>> on cucm >>>> >>>> phone1 (2001) has blf-speed dial to 4000 (CME phone) >>>> >>>> Route pattern 4XXX (Null partition )to SIP trunk (Towards CME) >>>> >>>> On SIP trunk , >>>> >>>> security profile is applied , valid check box ie accept presence sub >>>> and accept unsolicited are enabled. >>>> >>>> DN and trunk are in same presence group. Subscribe CSS can access DN >>>> 2001. >>>> >>>> when 2001 goes off hook , status can be seen on CME phone >>>> but other way , its not working. >>>> >>>> CUCM phone can make a call to CME phone by pressing BLF Speed dial >>>> >>>> Any missing config here ? >>>> >>>> Regards, >>>> Mritunjay >>>> >>>> >>>> >>>> >>> >> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
