Hey,
I would hard code the preferences. Being that the default preference
in canonical terms is 0, you could set the preference on the pub dial
peer to preference 1, or you could set the sub dial-peer to preference
1 and the pub to preference 2. Either way, I would hard code it.
Amp
Quoting CCIEing <aboaz...@gmail.com>:
I am sorry the below dial-peers should be :
dial-peer voice 2 voip
destination-pattern 12341....$
session target ipv4:Sub_IP_Address
codec g711ulaw
dtmf-relay h245-alphanumaric h245-siganal cisco
no vad
dial-peer voice 3 voip
destination-pattern 12341....$
session target ipv4:Pub_IP_Address
codec g711ulaw
dtmf-relay h245-alphanumaric h245-siganal cisco
no vad
On Sat, Mar 9, 2013 at 11:14 PM, CCIEing <aboaz...@gmail.com> wrote:
Hi All,
For site B let us say that the lab ask us to configure it as H323 gateway,
and the question mentioned that call have to go to SUB CUCM then to PUB,
in that case we have to create the 2 voip dial peers pointing to sub and
PUB as below :
My question here , in order to make sure the preference of the 1st dial
peer , do we have to hard coded the preference command in the dial-peers or
the tag index of the dial peer will grantee that the sup dial peer will
chosen 1st as it is tag is less than the pub dial-peer
Thanks
dial-peer voice 2 voip
destination-pattern 12341....$
session target ipv4:Sub_IP_Address
codec g711ulaw
dtmf-relay h245-alphanumaric h245-siganal cisco
no vad
dial-peer voice 2 voip
destination-pattern 12341....$
session target ipv4:Sub_IP_Address
codec g711ulaw
dtmf-relay h245-alphanumaric h245-siganal cisco
no vad
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com