Hello

do a packet capture on the router during the disconnect , analyse  the signal 
using Audacity and get the cadence and frequency

or get the capture send it to Cisco TAC and then they will get you the cadence 
and the frequency 

Regards
Moataz
 
From: Bill Lake <whl...@gmail.com>
To: CCIE Study <ccie_voice@onlinestudylist.com> 
Sent: Wednesday, 9 April 2014, 13:37
Subject: [OSL | CCIE_Voice] FXO revisited
 


Hi All,


Just wanted to let you know I think I know why it does not work.  Here is what 
the carrier sent me


switch goes through the timeout
sequence the first tone, the 480,  goes for 60 seconds and then the 620 is
overlayed onto the 480 and both tones are sent for another 60 seconds. There is
not an on/off cadence for these tone.
Then the  "howler"  tone
(ROH receiver off hook) is sent and it is comprised of 4 frequencies, 1440,
2060, 2450, 2600 and it is interupted at .25 second intervals



So I am trying to configure for this but since they have no cadence on the 
tones, I am not sure it will work.



If you have any ideas, give it a shout


Bill

_______________________________________________
Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos ::

iPexpert on YouTube: www.youtube.com/ipexpertinc
_______________________________________________
Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos ::

iPexpert on YouTube: www.youtube.com/ipexpertinc

Reply via email to