I would just like to add, make sure you reboot your AP's when you can't get something working, the amount of times I have hit a brick wall with these type of configs then rebooted and it all works is scary!
From: [email protected] [mailto:[email protected]] On Behalf Of Raul Manzano Sent: 08 June 2011 11:56 To: [email protected] Subject: Re: [OSL | CCIE_Wireless] [CCIE Wireless] Autonomous Mode Configs (Vit) Hi Guys. The configs, following the jason´s configuration it work fine on my lab :) Root: dot11 ssid WGB vlan 12 authentication open ! interface Dot11Radio0 ! ssid WGB ! channel 2412 station-role root bridge-group 1 ! interface Dot11Radio0.12 encapsulation dot1Q 12 no ip route-cache bridge-group 12 ! ! interface FastEthernet0 bridge-group 1 ! interface FastEthernet0.12 encapsulation dot1Q 12 no ip route-cache bridge-group 12 WGB: ! dot11 ssid WGB authentication open ! ! interface Dot11Radio0 ! ssid WGB station-role workgroup-bridge bridge-group 1 ! interface FastEthernet0 bridge-group 1 ! bridge 12 protocol ieee workgroup-bridge client-vlan 12 SWITCH: vlan 12 ! interface GigabitEthernet1/0/1 switchport access vlan 12 switchport mode access spanning-tree bpdufilter enable ! ! interface Vlan1 no ip address shutdown ! interface Vlan12 ip address dhcp client-id Vlan12 ! Both The Switch and WGB gets an IP through DHCP and can ping to the network through the Workgroup bridge link. Using native vlan in root ap is also working. root: interface Dot11Radio0.12 encapsulation dot1Q 12 native no ip route-cache bridge-group 12 ! ! interface FastEthernet0.12 encapsulation dot1Q 12 native no ip route-cache bridge-group 12 ! interface FastEthernet0.110 encapsulation dot1Q 110 no ip route-cache bridge-group 1 The rest of configurations remains the same. Best regards.
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
