Thanks again Jason for your answers, always very instructive. Best regards.
2011/6/21 Jason Boyers <[email protected]> > Raul > > Finally have a chance to respond here. Answers inline below. > > > Jason Boyers - CCIE #26024 (Wireless) > Technical Instructor - IPexpert, Inc. > Mailto: *[email protected] > * > > On Wed, Jun 15, 2011 at 9:16 AM, Raul Manzano <[email protected]>wrote: > >> Hi Guys. >> >> Working on lab 6 I have some questions about it. >> >> 6.1 Monitor user; the solution showed in DSG seems valid. I did other >> combination, I created the user in AD and created a AD group called "Tacacs >> monitor", then added the user to this group. Finally created in ACS Database >> group mappings pointing the AD monitor group to the ACS monitor group and >> mapping the rest to default group. I supposed both possibilities are the >> same because the exercise does not tell us that the monitor user should be >> created statically in ACS. Thoughs?? >> > *** While true, this involves extra configuration work both in AD and in > ACS. Therefore, the shorter answer is better in this case. > >> >> 6.3: Maps; Although in real life I do the same like the DSG creating a >> Building with bigger dimensions than the original and then pushes the floor >> plans in right position, this exercise talks about the "dimensions of the >> building". Because it is not talking about the properties of the floor (only >> the type of the floor), I suppose that it should be valid to create a >> building with these dimensions and then create the floor, using the same >> dimensions and uncheck "maintain aspect ratio" to maintain the dimensions >> used for the floor and building and match the requirements of the exercise. >> More thoughs? >> >> > *** That would be more accurate, with unchecking "maintain aspect ratio." > >> >> About this, I always had a doubt about the positioning of the aps. I >> always have assumed that when the ap is mounted in a ceiling, the >> elevation information for the ap is down and 0 degrees; if it is on a table, >> up and 0 degrees and on a wal, l up or down and the degrees in function of >> the position selected. Am I right?? Because I did not found information that >> explains clearly this point and can be more important if you are using RTLS >> with a Location Appliance or MSE. >> >> > *** The elevation information is specific to directional antennas. So, > "down 10 degress" would have the antenna pointing in a specific > direction/orientation (90 degrees is default orientation for this - pointing > to the bottom of the map,) with the antenna focused down 10 degrees from a > plane parallel to the floor. "Up 45 degrees" would have the focus of the > antenna pointing up 45 degrees from that parallel plane. So, think of the > orientation of the antenna on the "x" and "y" axes. The elevation would be > on the "z" axis. > >> >> Sorry for the huge number of e-mail sent in recent days. >> >> Best Regards. >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com <http://www.platinumplacement.com/> >> >> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
