Great work, Kristjan! Jason Boyers, CCIE #26024 (Wireless) Blog: netboyers.wordpress.com
2012/4/13 Kristján Ólafur Eðvarðsson <[email protected]> > Hey guys, > > The solution for my WGB - WLC foregin to WLC anchor is the following: > > facts: > The WGP as station role worgroup-bridge (default Cisco mode) works fine > directly to a internal 5508 controller > as IAPP works smoothly there. > > When the 5508 anchors to 4402 on a DMZ. The EtheroverIP tunnel makes the > game different. The DMZ controller > gives IP to the wired client behind the WGB but it doesn´t like to pass > traffic through since there is one MAC (the WGB) > asking for several IP´s to connect from the WGB. The IAPP is broken in > this situation. > > Luckily the solution is this CLI command on the DMZ anchor: > > config WGB vlan enable > > And traffic is passed through without more changes. > > This command does the following: > The DMZ Anchor says to the WGB. Give me a updated list of your clients and > I will pass them through as > normally I don´t like several IP´s to come from one association as I see > you by default. Thats why > I could´t list the wired cilent in my client table over the EtheroverIP > tunnel. > > Makes sense ? > > regards. Kristjan > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
