Thank you so much . Tomorrow I will do that and I will let you know about the result .
Best regards, Cisco2006 -------------------------------------------- On Wed, 19/2/14, Jeff Rensink <[email protected]> wrote: Subject: Re: [OSL | CCIE_Wireless] Remove Static IP from AP To: "cisco 2006" <[email protected]> Cc: "[email protected]" <[email protected]> Date: Wednesday, 19 February, 2014, 21:23 So you have actually logged in with user/pass? If not, press Enter to get the login prompt (console only). Once you are logged in, get into enable mode. At that point you can enter the commands. You can just ignore the normal log messages. They shouldn't prevent you from entering any commands. Though they can make it hard to read what's going on if there are a lot of them. If there is a debug running, just type in "undeb all" and that should get the debug messages to stop (might take a minute). Regards, Jeff Rensink : Sr Instructor : iPexpert CCIE # 24834 :: Wireless / R&S :: World-Class Cisco Certification Training Direct: +1.810.326.1444 :: Free Videos :: Free Training / Product Offerings :: CCIE Blog :: Twitter On Wed, Feb 19, 2014 at 12:19 PM, cisco 2006 <[email protected]> wrote: When I login to the AP , I just get logging messages . How can I stop them and write these commands on the AP ? Best Regards, Cisco2006 -------------------------------------------- On Wed, 19/2/14, Jeff Rensink <[email protected]> wrote: Subject: Re: [OSL | CCIE_Wireless] Remove Static IP from AP To: "cisco 2006" <[email protected]> Cc: "[email protected]" <[email protected]> Date: Wednesday, 19 February, 2014, 20:52 2 lines of config on the AP... clear capwap ap ip addressclear capwap ap default-gateway Regards, Jeff Rensink : Sr Instructor : iPexpert CCIE # 24834 :: Wireless / R&S :: World-Class Cisco Certification Training Direct: +1.810.326.1444 :: Free Videos :: Free Training / Product Offerings :: CCIE Blog :: Twitter On Wed, Feb 19, 2014 at 11:50 AM, cisco 2006 <[email protected]> wrote: Dear All, I have changed the IP address from Dynamic to static in one of APs 3600 through the WLC 5508 . After the change , the AP reload and it is not joined to the WLC . My question is that : How can I remove this static IP from the AP ? Best Regards, Cisco2006 _______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc _______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc
