Hi, I'm trying to set up CCNET to replace an older, existing continuous integration system.
I am getting a strange problem where CCNET successfully runs p4.exe, which outputs a stream of revisions to the console, followed by a large list of version numbers. After the list of version numbers, however, there is a complaint that p4.exe cannot be found, despite the fact that it was just running and it's output is in the line directly above. The tail-end of the output is as follows: 4494 4492 4491 4488 4485 4476 4471 4468 4467 4465 4464 4463 4451 4449 4440 4439 4438 4437 4414 4411 4410 4399 4397 4396 4395 4393 4392 4391 4389 4387 4376 4373 4371 4370 4367 4355 4342 4341 4331 4324 4323 4321 4319 4317 4316 4315 4310 4309 4308 4306 4305 4300 4299 4252 4251 4249 4246 4245 4244 4242 4241 4224 4217 4213 4212 4211 4206 4204 4203 4201 4200 4182 4177 4176 4175 4158 4157 4156 4155 4146 4145 4138 4134 4132 4130 4129 4124 4122 4120 4119 4118 4117 4110 4108 4106 4104 4103 4094 4092 4091 4086 4077 4067 4054 4049 4047 4044 4041 4039 4030 4029 4026 4025 3987 3986 3978 3977 3957 3933 3932 3926 3922 3920 3912 3910 3903 3899 3893 ] [MyFirstProject:WARN] Source control failure (GetModifications): Unable to execute file [p4]. The file may not exist or may not be executable. [MyFirstProject:INFO] Integration complete: Exception - 10/12/2010 4:01:37 PM During the procedure memory usage never goes beyond 50%. I have tried this both with and without the <executable> tags being used, the result is identical. Does anyone know what could be causing this? Thanks in advance, Jason
