On 5/13/2016 1:13 AM, Eric Smith wrote:
On Thu, May 12, 2016 at 9:38 PM, Jim Brain <[email protected]> wrote:
Not sure if I am completely understanding the concerns with the switches,
but:
* I would install the switches and run the top nut out to the very
end, then back the inside nut up to it on the other side of the bazel
* Once all switches are installed, then insert the board and solder.
Part of the problem is that with the commonly-available switches, the
push-button has a significantly shorter bushing than the toggles.
But, is it so short that it would not touch the PCB when soldered? If
not, I think you're OK.
Jim
