On Thu, 26 Jun 2025, ste...@malikoff.com steven--- via cctalk wrote:
Sure, by all means go for it. If you can make some sort of robust circumferential clamp to prevent axial sliding of the roll (think of a rolled up poster with one conical (convex) end and the other concave) due to imperfect rolling, and a resulting tape that doesn't exceed the nominal 1" width so it doesn't jam between the punch channel walls, then you'd be well on your way to possible success.
a pipe vice, or hose clamp(s) attached to a board Tightening your jig too much would daamage the outer couple of inches
