Helmut Jarausch <[email protected]> wrote: > Hi, > > having used (earlier) versions of cdrecord on the very same drive and > media brand, I got the following errors today (on two medias)
You did not send a cdrecord -v -minfo output to identify the medium. You did not send the cdrecord command line used for the call below and you seem to give it am empty file as parameter. > (This is with Linux kernel 2.6.26) > > Cdrecord-ProDVD-ProBD-Clone 2.01.01a55 (i686-pc-linux-gnu) Copyright (C) > 1995-2008 Jörg Schilling > TOC Type: 1 = CD-ROM > scsidev: '/dev/hdb' > devname: '/dev/hdb' > scsibus: -2 target: -2 lun: -2 > Warning: Open by 'devname' is unintentional and not supported. You are not calling cdrecord in the documented way. This may result in miss-behavior. > Linux sg driver version: 3.5.27 > Using libscg version 'schily-0.9'. > Driveropts: 'burnfree' > SCSI buffer size: 64512 > atapi: 1 > Device type : Removable CD-ROM > Version : 0 > Response Format: 2 > Capabilities : > Vendor_info : 'HL-DT-ST' > Identifikation : 'DVDRAM GSA-4167B' > Revision : 'DL11' > Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM. > Current: DVD-R sequential recording > Profile: DVD-RAM > Profile: DVD-R sequential recording (current) > Profile: DVD-R/DL sequential recording > Profile: DVD-R/DL layer jump recording > Profile: DVD-RW sequential recording > Profile: DVD-RW restricted overwrite > Profile: DVD+RW > Profile: DVD+R > Profile: DVD+R/DL > Profile: DVD-ROM > Profile: CD-R > Profile: CD-RW > Profile: CD-ROM > Profile: Removable Disk > Using generic SCSI-3/mmc-2 DVD-R/DVD-RW/DVD-RAM driver (mmc_dvd). > Driver flags : NO-CD DVD MMC-3 SWABAUDIO BURNFREE > Supported modes: PACKET SAO > Drive buf size : 1114112 = 1088 KB > Drive pbuf size: 1966080 = 1920 KB > Drive DMA Speed: 11772 kB/s 66x CD 8x DVD 2x BD > FIFO size : 67108864 = 65536 KB > Track 01: data 0 MB padsize: 30 KB > Total size: 0 MB = 300 sectors > Current Secsize: 2048 > Total power on hours: 6656 > Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 2298196 > Reducing transfer size from 64512 to 32768 bytes. > Starting to write CD/DVD/BD at speed 4 in real SAO mode for single session. > Last chance to quit, starting real write 0 seconds. Operation starts. > Waiting for reader process to fill input buffer ... input buffer ready. > BURN-Free is ON. > Starting new track at sector: 0 > Track 01: 0 MB written. > Track 01: writing 600 KB of pad data. > /usr/local/bin/cdrecord: Success. write_g1: scsi sendcmd: no error > CDB: 2A 00 00 00 00 00 00 00 10 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: F0 00 05 00 00 00 00 10 2A 00 00 0C 21 00 00 00 > Sense Key: 0x5 Illegal Request, Segment 0 > Sense Code: 0x21 Qual 0x00 (logical block address out of range) Fru 0x0 > Sense flags: Blk 0 (valid) > resid: 32768 > cmd finished after 0.001s timeout 200s > write track pad data: error after 0 bytes > BFree: 1088 K BSize: 1088 K > Track 01: Total bytes read/written: 32768/0 (0 sectors). > Writing time: 8.876s > Average write speed 0.1x. > Fixating... > Fixating time: 20.623s > /usr/local/bin/cdrecord: fifo had 1 puts and 1 gets. > /usr/local/bin/cdrecord: fifo was 0 times empty and 0 times full, min fill > was 100%. What is the cdrecord -v -minfo outoput? was this an empty medium before you started? If it was empty, you may have a non-collaborative application (like the Linux hald variant) runnung that disturbes writing. Try to kill/disable the Linux hald. You may have seen a buffer underrun. If Burn-Free was turned on, you may have turned DMA off. Try to turn on DMA. Try to use media that is known to be of good quality. Jörg -- EMail:[email protected] (home) Jörg Schilling D-13353 Berlin [email protected] (uni) [email protected] (work) Blog: http://schily.blogspot.com/ URL: http://cdrecord.berlios.de/private/ ftp://ftp.berlios.de/pub/schily -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected]
