Hi Aaron, On Oct 23, 2015, at 19:22 , Aaron Wood <[email protected]> wrote:
> > > On Fri, Oct 23, 2015 at 9:10 AM, Richard Smith <[email protected]> wrote: > I have a shiny new Linksys WRT1900ACS to test. > > I thought it might be nice to start with some comparisons of factory firmware > vs OpenWRT with sqm enabled. > > Here are my results with the same router (unless the WRT1900ACS is different > from the WRT1900AC): I believe the ACS is the success or the AC, basically using the same SoC @higher frequency as the 1200AC, which tested very well in Mikael’s tests recently. > http://burntchrome.blogspot.com/2015/06/sqmscripts-before-and-after-at-160mbps.html But that looks quite nice… Best Regards Sebastian > > > So I built and installed an openwrt trunk but the results were very > non-impressive. Rrul test reported mulit-seconds of latency and it was > equally non-impressive with sqm enabled or disabled. So I assumed that sqm > in trunk on this device must not work yet. Then I wondered how well sqm in > trunk was tested and that perhaps its broken for all devices. > > Trunk or the Chaos Calmer release? (I"m running CC RC1) > > My test setup: > > Laptop<--1000BaseT-->DUT<--1000baseT-->Server > > Which ports on the DUT were you using? are those local ports, or is one of > those the "internet" port? > > -Aaron > _______________________________________________ > Cerowrt-devel mailing list > [email protected] > https://lists.bufferbloat.net/listinfo/cerowrt-devel _______________________________________________ Cerowrt-devel mailing list [email protected] https://lists.bufferbloat.net/listinfo/cerowrt-devel
