Clint,
I haven't personally used their parts but I've seen several of
them. I have an old friend who owns a body shop. Dave does quite a few
of the older cars & uses a lot of their parts. He thought enough of
them to get set up as a Goodmark Distibutor.
Most recently, he's restoring a '70 LS6 car with 29,000 miles!
This car had spent the last 15 years parked outside & needs new quarter
skins.
Dean Vandergriff
-----Original Message-----
From: Clint Hooper [mailto:[EMAIL PROTECTED]]
Sent: Sunday, November 17, 2002 2:42 PM
To: [EMAIL PROTECTED]
Subject: Re: [Chevelle-List] Re: Repro Sheetmetal
What is the consensus about Goodmark sheetmetal? Is it US-made and if
so,is it any good? Clint Hooper LT5 Registry Director Wichita Falls,Tx
(940) 855-6636
'91 ZR-1 Callaway Aerobody
TX TAGS: USA ZR1
http://www.LT5Registry.net/
----- Original Message -----
From: Mach4 <[EMAIL PROTECTED]>
> John Nasta and others-
>
> I was told at a swap meet by a nationally known vendor that there are
> two primary manufacturers of repro sheet metal - hoods, fenders,
> quarters, floors, etc. One is pretty chinsy - poor fit, poor lines,
> etc - and the other was much better. Of course, all they carry is the
> better stuff...
>
> Do you have any comments or knowledge about this claim? Where does
> this stuff come from?
>
> Jim ACES #2020 2 - '66 SS's
-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]
-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]
