Those felpros should be just fine, but they could have a defect I would take the top end off measure the heads and the top of the block with a straightedge to ensure that everything is straight, once everything is straight and clean I would copper spray some NEW gaskets and install all the parts once more.
I know you'll have to throw away some new head and intake gaskets but whats $50 compared to what an engine costs Torque all bolts In the right sequence to half spec'd and take a coffee break, then torque to full spec and then start the engine, run it for a while and retorque once more ciao Med Vennlig Hilsen/Kind Regards/Cordiali Saluti Andr� Broe Jensen -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Graham Wooden Sent: 11. januar 2004 00:39 To: 'The Chevelle Mailing List' Subject: RE: [Chevelle-list] Wow - Engine runs but leaks from head gasket :^( They are the cheap Felpro set. I believe I torqued them to specs, which now makes me believe that I didn't. At any rate, I am about to go through them again and re-check. Thanks! -Graham. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dale McIntosh Sent: Saturday, January 10, 2004 6:29 PM To: 'The Chevelle Mailing List' Subject: RE: [Chevelle-list] Wow - Engine runs but leaks from head gasket :^( Depending on the gasket, they may or may not require retorquing after a time but in either case, there shouldn't be any leaking. Could be the head bolts weren't torque properly originally or possibly sitting with only air temp warming and cooling, they may have loosened up. Dale McIntosh I've stopped 98 spam messages. You can too! One month FREE spam protection at http://www.cloudmark.com/spamnetsig/ > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Graham Wooden > Sent: Saturday, January 10, 2004 5:03 PM > To: 'The Chevelle Mailing List' > Subject: [Chevelle-list] Wow - Engine runs but leaks from > head gasket :^( > > > Hi Folks, > > Well, this day finally happened - the motor fired right and > up and ran! Unbelievable; it was truly amazing to see it in > action, after it being on the engine stand for 2+ years now. > I really wanted to hear the gear-drive, but with open > headers, it's a tad hard ;-) However after about 6 minutes or > so breaking in the cam, 2 leaks started and I cut off the motor. > > A leak developed in the fuel pump, where the bottom half > (swivel) gasket started to leak. Kind of typical I guess of a > cheap two-piece unit. > > Another leak started with the head gasket; at the front end, > in-between the head & block - little coolant started to leak > out, which brings to the point of this email. Is this normal > - after the engine has warmed up for the first time and all? > I guess since things start to expand and what-not. Does the > head gaskets need to be re-torqued? > > Oh, by the way, John Nasta mentioned a while back about a > tool from K-D Tools, a "portable ignition system". If you > can locate one, I would highly recommend it. It's completely > rad! The engine can start and run without the car's ignition > system hooked up. I got one from eBay for about $25.00. >
