No problem buddy:o) I do believe you :O)
Have Fun André -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Graham Wooden Sent: 17. juli 2005 14:43 To: The Chevelle Mailing List; André-Tigergutt Subject: RE: [Chevelle-list] 12 bolt non-posi 'spider' gear installation Thanks Andre! I'll give these a try ... #6 and 7 were very popular steps of last night! -graham Quoting André-Tigergutt <[EMAIL PROTECTED]>: > LOL!!! > > I just answered your first email, and then I read your number two, > then your number three and started laughing. > > I can just say that they will fit with washers. > > Its been a long time but I remember it as follows: > 1 clean out the oil > 2 put one spider in with a washer > 3 block that one there with a plastic strip > 4 put the other spider half way in with the washer > 5 swear to do the above > 6 bust your knuckles > 7 swear again > 8 hammer it in using something soft like copper > 9 Secure it all with a plastic strip > 10 after you have installed axles and brakes and c clips you'll have > to put the crosspin in again 11 cut one plastic strip at the time and > enter the crosspin being careful to not loose the washers and spiders > and stuff and secure the crosspin bolt with loctite, add some lube > (remember additive if you have a posi) and go out and spin the tires. > > You might be tempted to put some thicker c'clips in to eliminate > endplay totally, dont do that! The axles need some endplay (I > remember 1/8" but could be wrong) due to thermal expansion. > > > > Have Fun > André > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Graham > Wooden > Sent: 17. juli 2005 03:41 > To: The Chevelle Mailing List > Subject: [Chevelle-list] 12 bolt non-posi 'spider' gear installation > > > My two spider gears fell out when I had the axels out of the housing. > I am not exactly sure how this happened, but I need to get them back > in there. I see that they both have to be lined up on the opposite > sides, but when their washers in place, I can't get them back in > there. > > Any thoughts? > > -graham > > 67 SS > > > > > > -- Graham Wooden, RHCE [EMAIL PROTECTED]
